David, I was able to connect the harness to the motor but for the life of me cannot get the pin out of the connector, any ideas on how to remove this. I have removed the plastic housing around the connector and pulled on #1, it won’t budge. pls let me know.
···
On Wed, Aug 12, 2020 at 11:57 AM Inwo via Electric Forum <electricforum@discoursemail.com> wrote:
| Inwo
August 12 |
- | - |
The MM plugs into the harness on end of the motor.
The spoof plugs into pin #1 of controller. Remove p1 and replace with female end of spoof.
Wire that was removed plugs into the male end of spoof wire.
Visit Message or reply to this email to respond to Inwo, Red1.
To unsubscribe from these emails, click here.