your gauge is out of calibration , easy fix . first thing run it till it goes into turtle and measure pack voltage . need to know if pack really is low . if it is then calibrate the volt gauge . do this with battery pack discharged to turtle level .
- turn key on
2: hold trip button down , push turn signal up then all the way down , then to center , release trip button . gauge will enter program mode .
- click turn signal up repeatedly until you get to soc , then press the trip meter one time . a number will come up , if you were showing 4 bars the number will probably be in the 40’s . click the turn signal down till it reads a singe digit . then push trip button one time . turn off key . turn back on and your gauge should now read red bar . you are good to go .
let me know what happens