# Turn signal problem

**URL:** https://community.electricforum.com/t/turn-signal-problem/3789
**Category:** Technical Discussions
**Created:** [October 8, 2013, 11:12am UTC](https://community.electricforum.com/t/turn-signal-problem/3789 "2013-10-08T11:12:33Z")
**Posts on this page:** 1
**Page:** 1

<div class="post-metadata">

### Author: ![spider445](https://avatars.discourse-cdn.com/v4/letter/s/ebca7d/32.png) [@spider445](https://community.electricforum.com/u/spider445)
#### Post date: [October 8, 2013, 11:12am UTC](https://community.electricforum.com/t/turn-signal-problem/3789/1 "2013-10-08T11:12:33Z")

</div>

Hi, new on the forum and had a question with my 2005 GEM ES, the factory turn signal has been bypassed with a Golf Cart style signal controller. I would like to remove this and go back to stock.

When I operate the factory turn signals they flash correctly on the dash display but I get the following results at the harness plug for the front and rear signals;

FRONT signal

Red/Blue constant 12v  
Green/Blue right signal activated 12v will flash on and off.  
Purple/Blue left signal activated no voltage  
Black Ground

REAR signal

Black/Blue constant 12v  
Gray/Blue left signal activated 12v will flash on and off.  
Purple/Blue right signal activated no voltage  
Black Ground

Also the e-brake wires have been removed from the switch.

Thanks in advance for your help.

Greg