# Turf switch

**URL:** <https://community.electricforum.com/t/turf-switch/3761>\
**Category:** GEM Forum\
**Created:** [September 19, 2013, 12:13pm UTC](https://community.electricforum.com/t/turf-switch/3761 "2013-09-19T12:13:10Z")\
**Posts on this page:** 1\
**Page:** 1

<div class="post-metadata">

**Author:** ![FIGMO](https://avatars.discourse-cdn.com/v4/letter/f/f9ae1b/32.png) [@FIGMO](https://community.electricforum.com/u/FIGMO)\
**Post date:** [September 19, 2013, 12:13pm UTC](https://community.electricforum.com/t/turf-switch/3761/1 "2013-09-19T12:13:10Z")

</div>

2002 Gem e825 - I bought 2 of these at auction, replaced batts in one .all is well with this one. the other one only runs in turf mode .! Switch is good I swap it with other one to be sure. Any idea’s ? Both units have had all updates done to them long before I got them. I noticed on the output side of the motor controller 2 wires marked cf1 & cf2 I was going to switch these to see if it would run in road mode! Good Idea ? If it does I would assume motor controller is bad. If It’s bad MC where do I send it to be checked out… Thanks
