# Programming Numbers

**URL:** <https://community.electricforum.com/t/programming-numbers/4090>\
**Category:** GEM Forum\
**Created:** [February 23, 2014, 9:08pm UTC](https://community.electricforum.com/t/programming-numbers/4090 "2014-02-23T21:08:16Z")\
**Posts on this page:** 1\
**Page:** 1

<div class="post-metadata">

**Author:** ![Susp3nc3](https://avatars.discourse-cdn.com/v4/letter/s/c37758/32.png) [@Susp3nc3](https://community.electricforum.com/u/Susp3nc3)\
**Post date:** [February 23, 2014, 9:08pm UTC](https://community.electricforum.com/t/programming-numbers/4090/1 "2014-02-23T21:08:16Z")

</div>

I have some numbers on my Gem that I am trying to figure out. I used a lot of the recommended settings from others but there are a few that are a lot different than another user that sent me his original settings. I am not sure where to put the settings at.

Below are my suspicious settings…that i think are wrong

Lines:  
22 Odometer Calibration - mine is at 150  
23 Error Compensation - 30  
24 Field Weakening start - 36  
27 Hour Meter Minutes - 30  
28 Fault Counter Pointer - 32  
29 Hourmeter 10/1 - 64  
30 Hourmeter Auxiliary 10/1 - 64  
33 Fault 1 -77  
34 BDI 1 -100

Through my Hourmeter 8 is filled mostly out through line 63 whereas another users wasn’t

97 Odometer .1 -3  
98 Odometer 10/1 -49  
99 Odometer 1000/100 -12

Any help is greatly appreciated.The other lines checked out with another user and then i used settings recommended on this forum for the rest. The ones above are the ones i cannot figure out if they are right.
