# GEM e6 error code 43 and 11 help please

**URL:** <https://community.electricforum.com/t/gem-e6-error-code-43-and-11-help-please/18703>\
**Category:** GEM Forum\
**Created:** [May 7, 2020, 11:53am UTC](https://community.electricforum.com/t/gem-e6-error-code-43-and-11-help-please/18703 "2020-05-07T11:53:28Z")\
**Posts on this page:** 1\
**Showing post:** 2

<div class="post-metadata">

**Author:** ![Inwo](https://yyz2.discourse-cdn.com/flex030/user_avatar/community.electricforum.com/inwo/32/1067_2.png) [@Inwo](https://community.electricforum.com/u/Inwo)\
**Post date:** [May 7, 2020, 1:19pm UTC](https://community.electricforum.com/t/gem-e6-error-code-43-and-11-help-please/18703/2 "2020-05-07T13:19:15Z")

</div>

The voltages seem ok. GE doesn’t tell us much about the internals.  
I believe the precharge could come from p17 through the coil from B+.  
I do know that the controller “senses” p17, and will not go into program mode until disconnected.

This might help. I have not seen it.

> [@Ge install and trouble tracing](https://community.electricforum.com/t/ge-install-and-trouble-tracing/18637):
>
> GEM INSTALL AND TROUBLE TRACE I have just received a set of instructions from FSIP with my last T1 Reman. IMHO it is better than outstanding installation and trouble tracing information. It basically takes the information from the manual and condenses it down to 4 easy to understand pages. If your interested email me [rodneyadiehl@aol.com](mailto:rodneyadiehl@aol.com) and ask for " Install and Troubleshoot GEM Electrics" Please leave feed back with your opinion.

For what it’s worth. I don’t know what armature offset voltage means. I can guess that its a voltage reading from the shunt. No load must have a specific range of voltages to verify shunt is working and motor is ok, before allowing car to run.

---

_[View the full topic](https://community.electricforum.com/t/gem-e6-error-code-43-and-11-help-please/18703)._
