# Factory Option Only?

**URL:** <https://community.electricforum.com/t/factory-option-only/4882>\
**Category:** GEM Forum\
**Created:** [April 5, 2015, 5:41am UTC](https://community.electricforum.com/t/factory-option-only/4882 "2015-04-05T05:41:54Z")\
**Posts on this page:** 13\
**Page:** 1

<div class="post-metadata">

**Author:** ![badfitter](https://avatars.discourse-cdn.com/v4/letter/b/97f17d/32.png) [@badfitter](https://community.electricforum.com/u/badfitter)\
**Post date:** [April 5, 2015, 5:41am UTC](https://community.electricforum.com/t/factory-option-only/4882/1 "2015-04-05T05:41:54Z")

</div>

Newbie here. Did a search and only found one entry from a while back with no reply.

I’m in the market for a used GEM 2-seater an really need hard doors. I currently travel to dog shows in a RV with a Club Car on a trailer and it gets really dirty. I frequently need to put the rain cover on at the shows but obviously the cart can’t travel on the trailer with the rain cover flapping in the wind.

A GEM with hard doors would be a good solution for me but I need to know if I can add hard doors or if they need to be an original factory installed option.

Thanks for your replies. I’m looking forward to being a GEM owner.

---

<div class="post-metadata">

**Author:** ![arandall](https://avatars.discourse-cdn.com/v4/letter/a/59ef9b/32.png) [@arandall](https://community.electricforum.com/u/arandall)\
**Post date:** [April 5, 2015, 5:01pm UTC](https://community.electricforum.com/t/factory-option-only/4882/2 "2015-04-05T17:01:54Z")

</div>

Unless you’re a fabricator I think you’ll find they are a factory only option. You might think about soft doors either canvas or vinyl as these can be aftermarket installs. Hard doors have a poor reputation in the community because of fit and cost issues in general.

---

<div class="post-metadata">

**Author:** ![badfitter](https://avatars.discourse-cdn.com/v4/letter/b/97f17d/32.png) [@badfitter](https://community.electricforum.com/u/badfitter)\
**Post date:** [April 5, 2015, 5:28pm UTC](https://community.electricforum.com/t/factory-option-only/4882/3 "2015-04-05T17:28:50Z")

</div>

Thanks but I’m not sure soft doors would survive 8 hours at 70 MPH on a trailer behind our RV.

Would they? Repeatedly?

---

<div class="post-metadata">

**Author:** ![arandall](https://avatars.discourse-cdn.com/v4/letter/a/59ef9b/32.png) [@arandall](https://community.electricforum.com/u/arandall)\
**Post date:** [April 5, 2015, 6:41pm UTC](https://community.electricforum.com/t/factory-option-only/4882/4 "2015-04-05T18:41:33Z")

</div>

Don’t know but seems unlikely. Don’t know about GEM WINDOW either. Maybe closed trailer?

---

<div class="post-metadata">

**Author:** ![badfitter](https://avatars.discourse-cdn.com/v4/letter/b/97f17d/32.png) [@badfitter](https://community.electricforum.com/u/badfitter)\
**Post date:** [April 6, 2015, 4:26am UTC](https://community.electricforum.com/t/factory-option-only/4882/5 "2015-04-06T04:26:09Z")

</div>

Thanks, I’m learning. I appreciate your help.

---

<div class="post-metadata">

**Author:** ![arandall](https://avatars.discourse-cdn.com/v4/letter/a/59ef9b/32.png) [@arandall](https://community.electricforum.com/u/arandall)\
**Post date:** [April 6, 2015, 1:37pm UTC](https://community.electricforum.com/t/factory-option-only/4882/6 "2015-04-06T13:37:43Z")

</div>

BTW I think soft doors are fairly easy to take off and put on and that may be another option though it wouldn’t address your rain and dust issue. I have a rain cover and I’d be tempted to try that and tie it down to the trailer or GEM to see how well that worked. I would think with the addition of some grommets at the bottom you could lash it down fairly tightly though I’ve not tried it myself. Also be sure GEM is Facing forward when you’re trailering it otherwise front window could blow out because of wind pressure. Finally I THINK I saw a recommendation to keep trailering speed to 50MPH as well but wouldn’t swear to it.

Depending on frequency, distances and other uses an enclosed trailer may still be the best option. You could load it with other dog material if you needed to haul more equipment, etc.

---

<div class="post-metadata">

**Author:** ![badfitter](https://avatars.discourse-cdn.com/v4/letter/b/97f17d/32.png) [@badfitter](https://community.electricforum.com/u/badfitter)\
**Post date:** [April 6, 2015, 2:39pm UTC](https://community.electricforum.com/t/factory-option-only/4882/7 "2015-04-06T14:39:06Z")

</div>

Enclosed trailer may be best. Thanks

---

<div class="post-metadata">

**Author:** ![Rascal](https://avatars.discourse-cdn.com/v4/letter/r/439d5e/32.png) [@Rascal](https://community.electricforum.com/u/Rascal)\
**Post date:** [April 8, 2015, 11:27pm UTC](https://community.electricforum.com/t/factory-option-only/4882/8 "2015-04-08T23:27:49Z")

</div>

When I bought my 2008 2 door with soft doors. I towed in 200 +/- miles at 70 (80 when passing) mph without any problems. I zippered my doors shut and duck taped the front edge of the canvas to the car. I had no problems other than cleaning the tapes stickum crap off the cart. Go for it…

Jerry

---

<div class="post-metadata">

**Author:** ![badfitter](https://avatars.discourse-cdn.com/v4/letter/b/97f17d/32.png) [@badfitter](https://community.electricforum.com/u/badfitter)\
**Post date:** [April 9, 2015, 3:47am UTC](https://community.electricforum.com/t/factory-option-only/4882/9 "2015-04-09T03:47:21Z")

</div>

Thanks Jerry

---

<div class="post-metadata">

**Author:** ![arandall](https://avatars.discourse-cdn.com/v4/letter/a/59ef9b/32.png) [@arandall](https://community.electricforum.com/u/arandall)\
**Post date:** [April 9, 2015, 4:10am UTC](https://community.electricforum.com/t/factory-option-only/4882/10 "2015-04-09T04:10:38Z")

</div>

Vinyl doors might be different than canvas however.

---

<div class="post-metadata">

**Author:** ![Rascal](https://avatars.discourse-cdn.com/v4/letter/r/439d5e/32.png) [@Rascal](https://community.electricforum.com/u/Rascal)\
**Post date:** [April 9, 2015, 12:59pm UTC](https://community.electricforum.com/t/factory-option-only/4882/11 "2015-04-09T12:59:21Z")

</div>

> [@ARandall;24258](#):
>
> Vinyl doors might be different than canvas however.

I was speaking generically. Mine are not heavy canvas. I don’t know what they are actually. The seem to be lighter weight and more on the vinyl side. They seem to be the norm sold in the 80’s here on GEM’s. We have three carts all the same soft doors in my hood. In my search back when I was interested in a GEM without doors, I could not find similar doors now for sale.

If I was smart enough to know how… I would post a picture.

Jerry

---

<div class="post-metadata">

**Author:** ![badfitter](https://avatars.discourse-cdn.com/v4/letter/b/97f17d/32.png) [@badfitter](https://community.electricforum.com/u/badfitter)\
**Post date:** [May 4, 2015, 3:34pm UTC](https://community.electricforum.com/t/factory-option-only/4882/12 "2015-05-04T15:34:18Z")

</div>

New to the stable. 2014 GEM eS with 82 hours.

---

<div class="post-metadata">

**Author:** ![rixgem](https://avatars.discourse-cdn.com/v4/letter/r/9d8465/32.png) [@rixgem](https://community.electricforum.com/u/rixgem)\
**Post date:** [August 17, 2015, 1:08pm UTC](https://community.electricforum.com/t/factory-option-only/4882/13 "2015-08-17T13:08:10Z")

</div>

I trailered mine for 150 miles on an open trailer. Dealer used a bungee cord to keep the soft canvas doors closed. Wouldn’t want to go too fast and suck them off!
