# Error code 11 then display shut off & lost power

**URL:** <https://community.electricforum.com/t/error-code-11-then-display-shut-off-lost-power/22399>\
**Category:** GEM Forum\
**Created:** [September 16, 2021, 3:05am UTC](https://community.electricforum.com/t/error-code-11-then-display-shut-off-lost-power/22399 "2021-09-16T03:05:03Z")\
**Posts on this page:** 1\
**Showing post:** 6

<div class="post-metadata">

**Author:** ![dougl](https://avatars.discourse-cdn.com/v4/letter/d/b19c9b/32.png) [@dougl](https://community.electricforum.com/u/dougl)\
**Post date:** [September 16, 2021, 3:41pm UTC](https://community.electricforum.com/t/error-code-11-then-display-shut-off-lost-power/22399/6 "2021-09-16T15:41:03Z")

</div>

I was getting -11 code while driving which didn’t cause stuff to stay powered down but it would stop applying power to the motor and I had to release the throttle and reapply throttle to get going again.  
I too went for the throttle pedal but that didn’t fix the problem. Eventually I found that the 72V wires to my 12V converter were intermittent due to a poor recall application. They put sealer on which got into the connector and limited the electrical contact surface area. Documented here: [Just purchased 2002 e825-4 where to start rejuvenation? - #87 by jagman](https://community.electricforum.com/t/just-purchased-2002-e825-4-where-to-start-rejuvenation/12708/87)

---

_[View the full topic](https://community.electricforum.com/t/error-code-11-then-display-shut-off-lost-power/22399)._