# COMPLETE list of GEM error CODES **URL:** \ **Category:** GEM Forum\ **Created:** [October 11, 2010, 11:05am UTC](https://community.electricforum.com/t/complete-list-of-gem-error-codes/1492 "2010-10-11T11:05:27Z")\ **Posts on this page:** 1\ **Showing post:** 1
**Author:** ![GEMmechanic](https://avatars.discourse-cdn.com/v4/letter/g/ecccb3/32.png) [@GEMmechanic](https://community.electricforum.com/u/GEMmechanic)\ **Post date:** [October 11, 2010, 11:05am UTC](https://community.electricforum.com/t/complete-list-of-gem-error-codes/1492/1 "2010-10-11T11:05:27Z")
Some of the following codes do not appear in the factory manual. Not all of these codes will necessarily apply to all model years. Corrective actions are listed following each code. Thanks to several other members and Ride for Fun who have provided new codes for this list. Also see my post listing the Zivan NG1 charger errors. [http://www.electricforum.com/cars/neighborhood-electric-vehicles-hev/2507-zivan-ng1-charger-error-codes.html](http://www.electricforum.com/cars/neighborhood-electric-vehicles-hev/2507-zivan-ng1-charger-error-codes.html) Complete list of GEM error codes: Error Code Description Fault To Correct none display is blank no power close master switch under seat, check fuses 02 car in reverse safety lock out move direction switch to neutral 03 car in forward safety lock out move direction switch to neutral 04 park brake on (normal condition) safety lock out release park brake 05 main relay not closing electrical fault inspect main relay and fuse 06 accelerator pedal closed safety lock out release pedal before selecting fwd or rev 08 pedal voltage high electrical fault check pedal voltage: \>0.9vdc when open 09 both fwd and rev selected electrical fault inspect direction selector switch 11 accelerator pedal stuck safety lock out check for debris or floor mat lodged under pedal 14 rolling radius or gear ratio are out of limits for motor inspect controller programming 15 voltage low low power charge batteries 16 voltage high electrical fault verify voltage \>86vdc, if higher, run lights to reduce 21 accelerator fault safety lock out inspect accelerator resistance and wiring 23 motor current high in rev electrical fault inspect motor controller 24 motor current high in fwd electrical fault inspect motor controller 27 12vdc supply low electrical fault check wiring, see manual 41 motor controller overheated electrical fault allow to cool, check for brake dragging and overweight 42 armature voltage high electrical fault inspect motor controller 43 armature voltage low electrical fault inspect motor controller 44 armature transistor failure electrical fault inspect motor controller 45 armature transistor failure electrical fault inspect motor controller 46 motor shorted to frame electrical fault check motor and wiring, if ok, inspect motor controller 49 motor current low electrical fault check resistance of motor and wiring,if ok, inspect motor controller 51 motor controller voltage low electrical fault check voltage, see manual 57 motor current sensor low electrical fault inspect controller 64 line driver input voltage low inspect controller 65 contactor coil current high inspect contactor and controller 66 field current high inspect motor controller 76 capacitor voltage high electrical fault inspect motor controller 77 vehicle over speed error inspect motor controller 81 no speed sensor signal is detected check sensor and wiring 82 check speed sensor and wiring or motor overloaded reset motor controller 90 terminal one is shorted to ground, input sensor error inspect motor controller Daniel --- _[View the full topic](https://community.electricforum.com/t/complete-list-of-gem-error-codes/1492)._