# 2016+ Cup Holders **URL:** https://community.electricforum.com/t/2016-cup-holders/21618 **Category:** GEM Forum **Created:** [June 9, 2021, 5:55pm UTC](https://community.electricforum.com/t/2016-cup-holders/21618 "2021-06-09T17:55:56Z") **Posts on this page:** 1 **Showing post:** 10
### Author: ![dougl](https://avatars.discourse-cdn.com/v4/letter/d/b19c9b/32.png) [@dougl](https://community.electricforum.com/u/dougl) #### Post date: [July 1, 2021, 8:15pm UTC](https://community.electricforum.com/t/2016-cup-holders/21618/10 "2021-07-01T20:15:10Z")
BTW, I started a thread about 3D printed parts a few years ago: > [@What 3D printed parts do people want or need](https://community.electricforum.com/t/what-3d-printed-parts-do-people-want-or-need/12825): > > I have a 3D printer and have used it to repair or improve our little RV trailer and I’ve run across a need for a part on our 2002 NEV I’ll just design in OpenSCAD and 3D print but was wondering if anyone else had any plastic parts they might need or want to improve the usability of the GEM. My first part will be a plastic spacer under the rear seat at the outer edge. It’s missing on ours and it keeps the set level between the spacers on each end and the hold-down pin in the middle. OpenSCAD de… --- _[View the full topic](https://community.electricforum.com/t/2016-cup-holders/21618)._