# 2000 GEM E-825 Changed batts, now won't go

**URL:** <https://community.electricforum.com/t/2000-gem-e-825-changed-batts-now-wont-go/2673>\
**Category:** GEM Forum\
**Created:** [September 10, 2012, 6:32pm UTC](https://community.electricforum.com/t/2000-gem-e-825-changed-batts-now-wont-go/2673 "2012-09-10T18:32:48Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![ghtaboma](https://avatars.discourse-cdn.com/v4/letter/g/c4cdca/32.png) [@ghtaboma](https://community.electricforum.com/u/ghtaboma)\
**Post date:** [September 10, 2012, 6:32pm UTC](https://community.electricforum.com/t/2000-gem-e-825-changed-batts-now-wont-go/2673/1 "2012-09-10T18:32:48Z")

</div>

Put in two new 12v batts (front). Now when the key is on, and the brake on, -109 shows on charge status. With brake off charge shows 225, not 100! Any advice? Thanks. Won’t go forward, or reverse.

---

<div class="post-metadata">

**Author:** ![GEMmechanic](https://avatars.discourse-cdn.com/v4/letter/g/ecccb3/32.png) [@GEMmechanic](https://community.electricforum.com/u/GEMmechanic)\
**Post date:** [September 12, 2012, 10:31am UTC](https://community.electricforum.com/t/2000-gem-e-825-changed-batts-now-wont-go/2673/2 "2012-09-12T10:31:23Z")

</div>

I don’t know of any codes higher than -77. If the voltage is too high you should get -16. If the voltage is too low, you should get -15. Check the combined voltage of all six batteries and ensure that they are connected together properly.

Daniel
